Operating precautions and installation of xenon lamp aging test chamber

Xenon lamp aging test chamber is a comprehensive climate test device. In addition to climate aging test, it can also be used to test the light resistance of high score materials. That is, polymer materials are exposed to artificial light source simulating the sunlight spectrum through glass to evaluate the light resistance of materials. With the continuous innovation of climate aging box technology, the control means are more and more advanced and high-tech, the control system tends to be more and more precise and standardized, so when the control system is more and more precise, it is necessary to pay attention to some problems. It is very necessary to operate the climate aging box in accordance with the correct process. The machine can be exempted from failure due to improper operation, and the correct maintenance method can prolong the life of the machine.

The best method of xenon chamber testing depends on the needs of the test, and each method is very effective. The appropriate test equipment should be selected based on the product or material being tested, the final application conditions, the degradation model and the budget considered.

Note: xenon lamp aging test chamber can exempt personnel from incorrect operation of the fault, the correct maintenance can extend the life of the test chamber.

1. During operation, unless it is necessary to open the door of the test chamber, please do not open the door of the equipment, otherwise it will cause adverse consequences.

2. Provide the instruction manual of testing products to protect the safety of test box operators. Please check the water pressure controller and water level of circulating water tank regularly.

3. The wet ball test cloth of the test device can ensure the correctness of the relative humidity.

4. Please read this manual carefully before operating the test chamber.

Xenon lamp aging test chamber installation location:

I. The installation location should take into account heat dissipation and maintenance of the usually easy to inspect location

Two. The distance between the running wall and other machines should have a small distance of more than 600mm.

Three. Set on the ground without vibration.

4. Choose a good ventilation mode to avoid direct sunlight.

V. The machine should be away from heat sources and inflammable and explosive materials.

Vi. Power supply lines and drainage pipes should be shortened as much as possible.

Seven. Please select less dust moisture and pass.