Do you know how to add water to the constant temperature and humidity test chamber to do humidity tests?

Constant temperature and humidity test chamber is also called high and low temperature humid heat test chamber, our equipment in the humidification work to do the test, we need to first check whether there is enough water in the water storage tank, if we find that the water is less, we need to add water first, we also need to pay special attention when adding water, adding water inside the box we recommend is to add barrels of pure water or distilled water can also be. Pure water is based on membrane separation equipment after each extraction process, the retention of all dissolvable salts and water content beyond 100 compounds of mineral water, the applicability of the conductivity and resistor to consider the water quality, which is the reason for the choice of filtered pure water when adding water to the constant temperature and humidity test chamber.

Constant temperature and humidity test chamber water refilling method.

 1, our equipment in a long time without using the humidity function, we need to first prepare a bucket of pure water or distilled water can also be, in the front part of the equipment test chamber right test to find the drawer to add water and water level indicator table.

2, then we pull the water drawer outward, open the pure water barrel, ready to add water to the constant temperature and humidity test chamber water tank.

3, we add water, from the water drawer to pour into the prepared good pure water or distilled water, and observe the water level indicator line below the drawer, when the water level reaches the middle of the scale when you need to slow down the speed of adding water, when the water level indicator scale reaches the middle of the scale value above half of the time the water level is more appropriate, the water level is too high will overflow from the tank.